Composition and properties: Dry grey cement based mix, mineral fillers and polymer additives.
Application: For indoor and outdoor use.
Adhesive for building aerated concrete and other cellular concrete for building inner and outer walls.
Base: The product is applicable on:
-Gas concrete blocks
Not applicable on: wood, metal, plastic, rubber, cement binding bases where the drying process is not finished.
Product data: Delivery form: 25 kg paper bags
Storage: In dry places on wooden grills in the original closed package for around 12 months
Application instructions: To work with “Adhesive for aerated concrete ” are needed: electrical or manual stirrer, broom or hard brush, notched mortar trowel, level, rubber/plastic hammer, vessel.
Application technique: Mix preparation: Add the mix into water in the following proportion 1:35 (water 0,27 kg/dry mix 1 kg) until reaching the needed density of the mix. Stay for 2-3 min and then stir again until the mix homogenizes.
Proportion: 6,75 l water for 25 kg
Laying: Stick the aerated concrete by pressing and level by gently knocking with a rubber/plastic rubber.
Following treatment: Clean the solution that exits from the fugues.
Safety regulations: Any specific information on composition, danger, cleaning and other measures can be viewed in the safety list.
Important instructions:
- Follow the norms and technical maps regarding base and cover
- Do not apply in temperatures below +5 C, direct sunlight, rain, strong wind
- High air humidity and low temperatures slow down the binding process while high temperatures speed up the process.
- Do not add other materials.
TECHNICAL DOCUMENTATION: Declaration of Performance Technical Map Safety List
EN 998-2
